Blog – Standard with both sidebars

This type of damage is not as bad as it seems and its quite repairable. These things happens for a number of reasons such as: 1.The use of excessive force when inserting the motor mount into the fuselage during the build. 2. Accidental knocks during transportation 3. Extremely high-G maneouver over-stressing the airframe (due very violent maneouver at...

Overview Here’s a simple way to rig up the solder-on lightweight servo extension cables for a neat installation and to get rid of excess weight. Items Required. 18W Low Power Soldering Iron Solder Flux paste 2mm and 6mm heat shrink insulation Cutting pliers Sharp Blade Electronic Work Centre Vise Needle nose pliers Lightweight servo cable Male servo...

How balancing cables are connected to Lipo Packs   Due to the non-standardization of current lipo manufacturers, there is no universal form factor for the balancing plugs and this becomes quite a nightmare for most EP enthusiasts owning a several brands of battery packs.   Although the JST-HXT form factor appears to be the most common “standard”...

High Performance 3D/Freestyle flying requires four critical considerations for battery packs which are; consistent power throughout the entire duration of the sequence, light enough to be within the prescribed AWT of the model to retain design flight characteristics, properly sized to accommodate the demands of the drive system and a long trouble free service life.   Lithium...

Prior to strating on the assembly you need the following:- A pair of scissors disposable lighter Good quality thin CA e.g. Zap Thin CA (Pink Bottle) Sand paper Step 1. Lightly sand the end section of the CF pushrod along the area where the metal Z-bend would be glued to. (This provides a much stronger glue bond)...